方太廚具研發大樓結構設計與分析
張路1，張龑華1，鄒明2
- 摘 要
-
（1 中國建筑設計研究院有限公司， 北京 100044； 2 北京建筑大學， 北京 100044）［摘要］方太廚具研發大樓地上4層，主體結構高度17.6m，采用含有少量剪力墻的框架結構體系，結構平面尺寸99m×73m。首先結合建筑方案及經濟性分析說明了主體結構的體系選型方案。隨后，系統介紹了項目設計過程中針對主體結構平面不規則、豎向不規則及其他不規則項選用的計算措施和設計措施。同時，對結構超長處理措施進行了具體陳述。最后，對基礎方案的比選進行了重點說明。研究及設計結果表明：通過選用合理的計算措施和設計措施，原結構的不規則性得到有效控制，結構各項計算指標可以較好地滿足規范要求，結構安全、可靠，結構設計可行。［關鍵詞］少墻框架； 不規則控制； 溫度應力； 抗浮設計；中圖分類號： TU352 文獻標識碼： A文章編號： 1002-848X(2016)S1-0202-04Structural design and analysis of the research building of FOTILEZhang Lu1, Zhang Yanhua1, Zou Ming2（1 China Architecture Design Group， Beijing 100044, China;2 Beijing University of Civil Engineering and Architecture， Beijing 100044， China）Abstract: Research building of FOTILE with the height of 17.6m and 4 floors on the grand, uses the less wall frame structure system and the plane dimension of 99m×73m. Firstly, combined architecture scheme and economic analysis, the structural system selection of the main structure is explained . Then, the calculation measures and the design measures about the plane irregularity, the vertical irregularity and the other irregularity of the structure were introduced systematically. At the same time, the treatment measures of super-long structure particularly were stated. Finally, the selection of the based scheme was emphatically presented. Research and design results show that, by using reasonable computational measures and design measures, the irregularity of the original structure has been effectively controlled, and the structure calculation index can better meet the requirements of the standards. The structure is safe, reliable and the structural design is feasible.Keywords: less wall frame; irregular control; thermal stress; anti-floating design作者簡介： 張路，博士，高級工程師，Email: 499686486@qq.com。
