- 摘 要
-
（1 同濟大學建筑工程系，上海 200092；2 先進土木工程材料教育部重點實驗室（同濟大學），上海 200092）
［摘要］對負載下碳纖維(CFRP)與鋼板復合加固鋼筋混凝土梁的抗彎性能進行了試驗研究和破壞模式分析，提出了復合加固梁的抗彎承載力公式。通過試驗和理論分析可知，復合加固大大提高了梁的抗彎承載力，并且負載對其抗彎承載力影響不大，當復合加固梁的破壞為CFRP拉斷時，其抗彎承載力幾乎不改變，并在此基礎上分析了負載對粘鋼、CFRP和復合加固3種加固方式的影響。結果表明，對于低強度混凝土梁，負載對粘鋼加固梁影響最大；而對于高強度混凝土梁，負載對CFRP加固梁影響最大。從加固設計角度考慮，低強度混凝土梁建議采用粘鋼加固，而高強度混凝土梁建議采用復合加固。
［關鍵詞］CFRP；鋼板；復合加固；負載；抗彎承載力；影響因素
Experimental research and parametric analysis on flexural performance of reinforced concrete beams combination strengthened with bonded CFRP and steel plates under sustaining load
Xiong Xueyu1,2, Xu Haifeng1（1 Department of Building Engineering, Tongji University, Shanghai 200092, China; 2 Key Laboratory of Advanced Civil Engineering Materials(Tongji University),Ministry of Education, Shanghai 200092, China）
Abstract:The experimental research on flexural performance of reinforced concrete beams combination strengthened with bonded carbon fiber reinforced polymer(CFRP) and steel plates and analysis of failure modes had been performed, the formula of the flexural capacity was put forward. Experimental research and theoretical analysis results show that combination strengthened method can effectively improve the flexural capacity of RC beams,and the sustaining load has not obvious effects on the flexural capacity and it even hardly changes when failure is CFRP tensile rupture.On the basis of the analyses, the sustaining load influenceing bonded steel plates, CFRP and combination strengthening was also analyzed. The results show that the sustaining load has the greatest influence on lower strength concrete beams reinforced with bonded steel plates, however, has the greatest influence on the higher strength concrete beams reinforced with CFRP. In the view of strengthened design, lower strength concrete beams reinforced with bonded steel plates and higher strength concrete beams reinforced with combination strengthened are suggested.
Keywords:CFRP; steel plate; combination strengthening; sustaining load; flexural capacity; influencing factors
上海市建設技術發展基金資助項目（B05043），上?，F(xiàn)代建筑設計（集團）有限公司研究課題（20061B006—結）。
作者簡介：熊學玉，博士，教授，Email：millerxuhaifeng@163.com。
參考文獻
［1］DUTHINH DAT, STARNES MONICA. Strength and ductility of concrete beams reinforced with carbon fiber-reinforced polymer plates and steel［J］. Journal of Composites for Construction, 2004, 8(1):59-69.
［2］OCHOLA R O, MARCUS K, NURICK GN, et al. Mechanical behavior of glass and carbon fiber reinforced composites at varying strain rates［J］. Composite Structures, 2004, 63(3-4): 455-467.
［3］MARCO A, PISANI. Evaluation of bending strength of RC beams strengthened with FRP sheets［J］. Joural of Composites for Construction, 2006, 10(4):129-136.
［4］歐新新，張文華，王紀峰. 鋼筋混凝土梁粘鋼加固受彎性能強度研究［J］. 浙江工業大學學報，1999，27(1)：23-27.
［5］盧亦焱，周婷. CFRP布與鋼板復合加固鋼筋混凝土梁抗彎性能試驗研究［J］. 鐵道學報, 2006, 28(1):80-87.
［6］GB50010—2002混凝土結構設計規范［S］.北京：中國建筑工業出版社，2002.
［7］CECS146—2003 CFRP片材加固修復混凝土結構技術規程［S］.北京：中國計劃出版社，2003.
［8］李貴炳，張愛暉，金偉良.持載下外貼纖維布加固RC梁抗彎性能研究［J］.浙江工業大學學報，2005，39(1)：70-75.
［9］GB50367—2006混凝土結構加固設計規范［S］.北京：中國建筑工業出版社，2006.
［10］王文煒，趙國藩，黃承逵，等. CFRP布加固已承受荷載的鋼筋混凝土梁抗彎性能試驗研究及抗彎承載力計算［J］. 工程力學, 2004, 21(4):172-178.
